How do you assign a layer to one of the two panel switches? I went to enable on and couldn't find either of the two switch assignment names PSw1 - PSw2. what am I doing wrong?

-- BEBOP (BSRITCHI@UOP.COM), December 21, 1998

Answers

Sorry for the delay in answering your question. It appears that I missed a number of posts to this forum.

If you want a layer in a program only to be activated by a switch. Do this: Go the LAYER PAGE of the program are working with. Find the ENABLE paramter. Put the cursor there. Press and hold the ENTER KEY. Then press the controller which you want to use to activate the layer.

Hope this help,

-- Mike Martin (K25zone@aol.com), March 04, 1999.