I AM A NEWBEE AT DCC WIRING. I HAVE AN E6 AND E7 WITH THE DCC PLUGINS. NEEDLESS TO SAY, AFTER PLUGGING IN THE DECODER NOTHING HAPPENED. THERE MUST BE MORE WIRING NECESSARY. ANY HELP WILL BE APPRECIATED. THANKS!

-- james brooks (terrie@iwon.com), March 22, 2000

Answers

You need to provide more information about the loco, decoder and DCC system. If it's an HO LL P2K E6/7, it is DCC ready and should have worked. Mine did. Does the DCC system work qith other DCC equipped locos? Have you tested the decoder? Did the loco work on DC? Is anything working (lights)? Have you programmed the decoder to the correct address?

-- Tomas Szoboszlai (TomasSz@banet.net), April 13, 2000.

Also you might check that the plug attached to the decoder is installed in the correct way. If yo have put it in backwards, nothing will work. Dave

-- Dave Poor (dwhstj@webtv.net), April 20, 2000.

THANKS FOR THE HELP. THE PLUG WAS IN BACKWARDS. TO SEE THE GUIDE TABS ON THE SIDES ONE MUST HAVE VERY GOOD EYES.

-- james brooks (terrie@iwon.com), April 20, 2000.